CRS UniRec2 universal multifrequency receiver with 2 channels
CRS UniRec2 universal multifrequency 2-channel receiver is a 2-rele receiver, compatible with 601 different models of remote controls.

Description
Universal receiver with 2 CRS channels UniRec2, is a multifrequency receiver with 2 relays, used to replace a non-operational receiver, a jumper-code receiver or to add a new frequency to an already existing one. It is also capable of controlling one or two functions with a remote controls (e.g. lights, small motors, a pump etc.)
The frequency can be set easily, using the "Prog" button and the relays can be configured independently, on each channel. Radio receiver compatible with up to 60 different remote controls, with fixed code or rolling code.
The product is manufactured in Europe, has a modern design and contains instructions for use in printed format. The remote controls can be used with the same radio receiver if they have the same frequency.
Specifications:
- Due to the voltage regulator, consumption and power waste are greatly reduced.
- The modes of action of the relay: monostable, bestable, timeless.
- Optional memory: there is the possibility to place additional, non-volatile, M24C32-W memory to increase the maximum number of remote controls supported up to 1000. In this case, the configuration can be found on this memory, possibly being moved to another receiver or duplicated with an eeprom programmer.
- Master remote control: One or more remote controls can be programmed for a certain channel. Instead of being activated for the appropriate channel, they will enter the programming mode. In this case other remote controls will be programmed from the distance, without moving to the receiver.
Telecom storage:
- Press the "Prog" button once or twice, according to the selected channel. The led will become green;
- Press the "Prog" button twice to activate the mode of learning. The led will blink easily;
- Press the button on the remote that needs to be logged. Whenever a new code is stored, the led blinks twice for successful programming. 3 times if it is already stored and 6 times if memory is full;
- During the memorization phase, the sensitivity of the receiver is reduced, not to accidentally memorize unwanted codes, transmitted incidentally from a distance.
Deleting codes:
- Press the Prog button once or twice, according to the selected channel. The led gets green;
- Press "Prog" three times, then press the remote control button. The led will click 4 times on each deleted code;
- For complete memory deletion, press "Prog" 10 times, wait for the led to blink;
- Finally, press "Prog" three more times.
| Technical characteristics: | |
| Frequency of operation: | 433.42÷434.42MHz, 869.3÷868.8MHz |
| BP: | 7-27 Vac, 6-36 Vdc |
| Module: | OOK (AM), 12.5KHz and FSK (FM), 25KHz |
| Maximum consumption: | 100mA (6Vdc), 23mA (36Vdc) |
| Length of band: | 250KHz |
Technical specifications
| Product code | CRSUNIREC2 |
|---|